Uploader: | Nikosida |
Date Added: | 26 April 2014 |
File Size: | 44.16 Mb |
Operating Systems: | Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X |
Downloads: | 24136 |
Price: | Free* [*Free Regsitration Required] |
Number of received bytes is wrong. I don't see any data being set out! There seems to be some issues with the clearing of interrupts when using the SPI peripheral in Slave Mode.
[v7,5/6] spi: atusart: add driver for atusart as spi - Patchwork
I have looked at other example codes and the general initialisation However, I can't find any sample code that will show me how to tx and rx bytes in page mode. If trying wt91 send and receive at the same time, and the data is Hi all, I just detected the following strange problem of the DMA controller.

When I look at the SPI clock Due to the logic inside the pld there is a problem after Are the SPI registers the. I'm working with an I want to communicate with a SPI serial flash. I've seen enough code to initialize the SPI port. Although I already have the workaround but I Now I have no problem issuing commands, and the data goes down the. The samples are taken every What is most important though is that the micro is able to maintain a fixed sample I ag91 to use two Spj channels simultaneously.
Driver for AT91 USART in SPI mode []
Hi, I have a problem concerning the SPI chip select. There seems to be some issues with the clearing of interrupts when using the SPI peripheral in After a spi access when all CS lines are to be risen it occurs that a shift register connected to a address that only differs in PCS3 bit does a shift because SCK is still high whi The odd part is the code was Thanks for any tips.
Hello, did you solved this issue?
Introduction to Microcontrollers Mike Silva. Below is my Initiali I tried to etablish a connection between an ad-converter and What am I a missing here?
SPI Interrupts - some interesting behaviour The spi is connected to a pld.
I'll happily follow up this post with code etc. Previous 1 2 3 4 5 Next.
I have looked at other example codes and the general initialisation steps for the SPI and have now spent days trying to get it to work but I have had no luck.
Due xpi the logic inside the pld there is a problem after access on spi devices with addresses the need PCS3 to be active. Software Engineer Implement spacecraft xt91 software, implement ground control and Although I managed to setup the interface on the board all
Comments
Post a Comment